Guard-N-Edge Protective cover for metal landscape edging.

Guard-n-Edge™ by Ren Concepts is a decorative, protective cover for metal landscape edging. It is designed to protect people and pets from sharp and potentially dangerous metal edging

Guard-n-Edge™ by Ren Concepts is a safe solution that converts unsightly metal edging into a decorative landscaping border. It is easy to install and will beautify your garden and yard.

Installing Guard-n-Edge™

Installation Instructions on Metal Edging
Cutting Guard-n-Edge™
Installing the Guard-n-Edge™ End Protector

Installation Instructions on Metal Edging:

1. Before you start: remove all the “U” shaped edging stakes on the existing metal edging.
This is best done with gloves and pliers.
Installing Guard-N-Edge - Remove edging stakes

Installing Guard-N-Edge - Remove edging stakes

2. Start at one end and press Guard-n-Edge™ firmly over the metal edging.
If needed, use only a soft faced mallet to tap Guard-n-Edge™ into place.
Installing Guard-N-Edge - press Guard-N-Edge over metal edging

Installing Guard-N-Edge - press Guard-N-Edge over metal edging

3. Install the “U” shaped edging stakes over Guard-n-Edge™ to secure edging.
(One stake per linear foot is recommended.)
Installing Guard-N-Edge - install new edging stakes

Installing Guard-N-Edge - install new edging stakes

4. (Optional) For maximum safety drill through provided holes and install pop rivets
to secure Guard-n-Edge™ as a more permanent installation.
Installing Guard-N-Edge - install rivets

Installing Guard-N-Edge - install rivets

5. Continue to install using the same method, one piece at a time until entire
edging is complete.

Cutting Guard-n-Edge™

A hacksaw can be used to cut Guard-n-Edge™ to any desired length. Another method is to score the flex joint at the desired length on both sides with a utility knife and then simply break Guard-n-Edge™ on the scored joint.

Installing Guard-N-Edge™ End Protector

Start the end protector spike over the corner of the metal edging and then use a soft faced mallet to pound into place. Secure with standard “U” shaped edging stakes.
Installing Guard-N-Edge - install end spike

**Do not pound on this product to force metal edging into the ground**

Caution: Always wear proper protective safety apparel
and eye protection when installing this product